Elektralite P100 Manual Part Two Uživatelský manuál stáhnout pdf (Strana 71)

143

Procedure for resetting the default CMOS setting.

The following procedure is for CP-100 consoles that have had their CMOS default settings altered.

This error can occur as a result of static shock or heavy electrical fluctuation in various environments.

The solution is possible to do without a monitor connected. However it is a darn sight easier if you

can connect one up. If you want to connect up a monitor you are going to have to have fitted a video

card. Video cards are available from your Elektralite distributor or from Elektralite direct.

SYMPTOM

: The Disk Drive appears not to work.

SOLUTION

: Perform the following steps.

Connect a standard Windows 95 keyboard to the keyboard jack on the rear panel of the console.

Power up the console.

Hold the “Del.” button on the keyboard for 15 seconds.

Press “Enter”

Press the down arrow key 8 times.

Press the “Page Up” key 2 times.

Press “Esc.”

Press the down arrow key 3 times.

Press “Enter”

10-

Press “y”

11-

Press “Enter”

12-

Press “F10”

13-

Press “y”

14-

Press “Enter”

15-

Wait for complete reboot of the software (approximately 30 seconds)

This restores the default settings of the operating system and reconfigures it to recognize the diskette

drive.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 79 80

Žádné komentáře

Elektralite P100 Manual Part Two Uživatelský manuál Strana 71